![]() Increase the separation between the equipment and receiver.Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. ![]() This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. This device must accept any interference received, including interference that may cause undesired operation.Ĭhanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.įCC Interference Statement (Part 15.105 (b)) (USA only).This device may not cause harmful interference, and.Operation is subject to the following two conditions: This device complies with Part 15 of the FCC Rules. Gateway is Registered to Regulatory informationįCC Compliance Statement (Part 15.19) (USA only).Gateway is Connected to the RedLINK system.Red: The RedLINK Internet Gateway is not communicating with the RedLINK system. Green: The Gateway is connected to the RedLINK system Green (flashing): The Gateway is connecting to the RedLINK system Off: The Gateway is not connected to the RedLINK system The Internet LED will be amber during this time. If there is a continuous ping error to the servers, RIG will release the IP and capture it again.RIG will work with the server it can reach, but will regularly ping servers that didn't give a response to see if the connection is restored.RIG will flash red at 1Hz if it cannot ping all servers.If at least one can be reached, the Internet LED will be solid green. If there is no response, then the ping action failed. The RIG waits for up to 15 seconds for a response. The RedLINK Internet Gateway (RIG) pings a specific server approximately every 5 seconds. Solid Amber: Ethernet Connection Detected (cable connected and Gateway is retrieving the IP address).Solid Red: No Ethernet Connection (cable disconnected or Ethernet connection error).Provide company business card so that the homeowner can enter your contact information.Log in and register the gateway at by entering the MAC ID and MAC CRC found on the bottom of the device.Instruct the homeowner on the account set up and registration process. Press and release the CONNECT button on the bottom of the RedLINK internet gateway. If the thermostat is linked to an HZ322 or HZ432 zone panel with a THM4000R wireless adaptor, then the zone panel is the host (up to 3 thermostats per HZ322 and up to 4 thermostats per HZ432).įor assistance with this product please visit or call Honeywell Customer Care toll-free at 1-855-Red-Link (85)Ĭonnect the power cable to the RedLINK internet gateway.Ĭonnect the power adapter to a wall socket.Ĭonnect an Ethernet cable from the RedLINK internet gateway to an internet-connected home router.Įnter the WIRELESS SETUP MODE on your thermostat (refer to thermostat instructions).If the thermostat uses an EIM (Equipment Interface Module), then the EIM is the host (one thermostat per EIM).A thermostat that is wired to the heating/cooling equipment, or to a zone on a zone panel. ![]()
0 Comments
Leave a Reply. |